ISO 9001:2015 certified · Bengaluru & Chennai, India

Published 2 November 2026 · ST Chem Solutions technical team

Why friction matters

As wells get deeper and more deviated, more of the drill string lies against the borehole wall or casing. Friction at those contact points shows up as torque when rotating and drag when tripping. High torque and drag limit how far you can drill, slow sliding with motors, and add to the risk of stuck pipe.

What a drilling lubricant does

A drilling lubricant forms a film on metal and formation surfaces that lowers the coefficient of friction between them. In water-based muds this can:

  • Reduce torque and drag in deviated and extended-reach wells
  • Make sliding with a downhole motor smoother
  • Lower the risk of differential sticking across permeable zones
  • Reduce wear on the drill string and casing

Measuring lubricity

Lubricity is measured with an EP (extreme pressure) lubricity tester. A steel block is pressed against a rotating steel ring immersed in the mud, and the torque needed to keep the ring turning shows how much friction the mud allows. In the standard procedure the tester runs at 60 rpm with a 150 in-lb load and is first calibrated with water.

The result is reported as a coefficient of friction. The useful number is the comparison: the same mud tested with and without lubricant, at several concentrations, to show the percentage reduction in friction.

Choosing and dosing a lubricant

  • Compatibility: check that the lubricant does not cause foaming, grease out with hardness, or upset rheology and fluid loss
  • Concentration: lubricants are usually added as a percentage by volume; find the point where extra product stops giving extra friction reduction
  • Temperature: test at conditions close to downhole where possible
  • Environment: confirm the lubricant meets local discharge rules for the area

Lubricant or something else?

Not every torque problem is a friction problem. Poor hole cleaning, cuttings beds, tight hole from swelling shales or a doglegged well path all raise torque and drag too. Check those causes first; a lubricant works best once the hole is clean and in good condition.

Test before you treat

We supply a high film-strength drilling lubricant for extended-reach and horizontal wells, and our laboratory runs lubricity tests on our in-house designed EP lubricity tester to show its effect in your mud. We also supply the EP lubricity tester itself.

Have a drilling fluid challenge?

Share your requirement, quantity or well conditions. Our technical team replies within one working day.

Start a Technical Discussion →